HONDA AERO 750 CRUZER EXHAUST SYSTEM REMOVAL And INSTALLATION
download Install mounting bracket (stamped 363-P) in the original muffler mounting position, using two 10mm bolts and one 10mm nut. (supplied)(Refer to figure 2). 2. Mark outside surface of front and...
View ArticleYAMAHA V-STAR 650 EXHAUST SYSTEM REMOVAL AND INSTALLATION
download REMOVING THE STOCK EXHAUST SYSTEM 1. Remove the right hand frame cover to avoid scratching it. 2. Remove the nuts that mount the rear header to the cylinder head. 3. Loosen the pinch clamp on...
View ArticleToyota Tacoma 2001-2003 Dash Pad Removal & Installation Procedures
Download During a test drive, locate the noise source by using the palm of your hand to apply pressure on the suspect area or by grasping and holding onto the suspected source. When disassembling the...
View ArticleToyota Celica GT 2000- 2003 5 speed and automatic REMOVAL and INSTALLATION
Download Remove the OBD canister, vacuum switching valve and air temperature control sensor from the air box without removing any vacuum lines. Once all sensors have been removed take out the remaining...
View Article1988 – 1995 V6 Truck, 4Runner 3VZ CYLINDER HEAD INSTALLATION and REMOVAL
download Install cylinder head a. Place a new cylinder head gasket on the engine block and install cylinder head. b. Apply a light coat of engine oil on the threads and washer face of the cylinder head...
View ArticleYAMAHA V-Star 1100 Carburetor Bowl Screw Repair and Removal After Stripping...
download When I first started working on bike many years ago, I learned the danger of stripping the heads of Philips screws when removing or installing them on motorcycles. I remember the two worst...
View ArticleHarley-Davidson V-Rod Destroyer Indy Series Exhaust REMOVAL AND INSTALLATION
download STOCK EXHAUST SYSTEM REMOVAL (DESTROYER) 1. Remove both collector bolts. 2. Remove nuts from both front and rear exhaust cylinder head flanges using a 13mm socket. 3. If the Racepak is...
View Article2001-2003 XV16 Fuel Pump and Carburetor Removal
download Disconnect the carburetor fuel line hose at the fuel pump. •Disconnect the fuel pump wire coupler. •Remove the choke cable from fuel pump bracket. •Remove the upper engine mount, leaving the...
View ArticleYAMAHA VIRAGO 700/ 1100 2 into 2 EXHAUST SYSTEM REMOVAL AND INSTALLATION MANUAL
download REMOVING THE STOCK EXHAUST SYSTEM 1. Loosen the slip joint clamp on the front and rear head pipe, which are located at the muffler box. 2. Remove the two nuts that hold the front head pipe to...
View ArticleKawasaki 900/1100 Billet Head Installation And REMOVAL Instructions
download 1) Remove stock head and clean the top surface of the cylinder. 2) Remove the stock water fitting from the stock head and install it in the ADA Racing® billet head in the center cylinder...
View Article
More Pages to Explore .....